|
|
|
Home & Information
Technical Support
ADB Products
Related Products |
Artistic Licence 
Navigation:
HOME |
Artistic Licence overview
> Ethernet
> Tour-Lynx
|
Tour-Lynx
 |
| Tour-Lynx Rackmount Ethernet Power Inserter |
Tour-Lynx is a Mid-Span Power Inserter for 10BaseT Ethernet.
It is used to add low voltage power (24V) to the Ethernet cable. It connects between the hub and powered Ethernet devices. This allows products such as Net-Lynx to be powered over the CAT5 cable.
Tour-Lynx is primarily intended for touring racks. It will normally be installed into a rack next to the Ethernet hub. This allows for front panel patch cables to make the hub connection. The powered ethernet devices are then connected to the front panel Neutrik Ethercon connector. This supplies both power and data. Power to each output is limited to 400mA by an electronic fuse.
The front panel provides latching Neutric Ethercon RJ45 connectors for connection to an external Ethernet hub. No power is applied to the front panel connectors. A total of twelve ports are provided. These are split into two banks of six. A power supply is required for each bank of six outlets.
Alternatively, Insta-Lynx can be used as a 10BaseT CAT5 termination panel without power.
Features
12 Ethercon connectors for hub patch
12 Ethercon connectors for powered devices
Insert power on to CAT5 cable
Electronic cable protection
Power state indication
Reverse polarity protection
Latching Ethercon RJ45
Specifications
Listing: CE FCC
IP Rating: Indoor use
Output Voltage: 24VDC
Output Current: 400mA per outlet
Height: 2RU
Width: 19" Rack
Depth: 110mm
Weight: 0.5kg
See also:
- Go back
- Artistic Licence Ether-Lynx
- Artistic Licence Insta-Lynx
|
 |
 |